Mig With Gas Installation - Unimig VIPER Operating Manual

MIG WITH GAS INSTALLATION

1. Select the MIG function with the MIG/MMA selector switch.
2. Select Standard using the Standard/Spool Gun selector switch (Inside machine).
3. Connect the welding torch into the Euro Mig torch connection socket on the front panel, and tighten it.
4. Insert the earth cable plug into the required polarity and tighten - negative (-) for gas shielded wires, positive (+) for gas less wires. The weld power
cable goes into the opposing negative (-) or positive (+) socket.
5. Connect Gas Line to Gas Regulator and connect the gas regulator to the Gas Cylinder.
(6) Fit the correct type and size of drive rollers. V
Groove for Hard Wires. U Groove for Aluminium.
Knurled for Flux Cored
12 | VIPER MIG 185 Manual
4 (-)
3
(7) Place wire onto spool holder - (spool retaining nut is
left hand thread ) Feed the wire through the inlet guide
tube into the drive roller.
5
1
4 (+)
(8) Feed wire over the drive roller into the outlet guide
tube, Push the wire through approx 150mm.