Lift Arc Dc Tig Welding Setup - Unimig VIPER Operating Manual

LIFT ARC DC TIG WELDING SETUP

1. Switch on the machine, select the TIG function with the TIG/MMA/Mig selector switch.
2. Insert the power cable plug of the TIG torch into the Negative socket on the front of the machine and tighten it.
3. Insert the earth cable plug into the Positive socket on the front of the machine and tighten it.
4. Connect the gas line of the TIG torch to regulator and connect the regulator to the gas cylinder.
Assemble front end parts of the TIG torch.
(5)
2(-)
(6) Carefully open the valve of the gas cylinder, set the
flow to 6-10 l/min
4
1
3(+)
(7) Set the welding current using the amperage control
dial.
VIPER MIG 185 Manual | 29