Mig Torch Liner Installation - Unimig VIPER Operating Manual

MIG TORCH LINER INSTALLATION

(1) Remove MIG torch front end parts
(4) Carefully unravel the new liner, avoiding
creating any kinks in the liner.
(7) Snip the liner off 3mm past the end of the
torch neck.
18 | VIPER MIG 185 Manual
(2) Remove the liner retaining nut
(5) Carefully feed in the new liner down the torch
lead all the way to exit the torch neck.
(8) Replace the front end parts
(3) Carefully pull out and completely remove the
liner
(6) Fit the liner retaining nut and screw only 1/2
way down.
(9) Fully screw down the liner retaining nut and
nip it up tight. This compresses the liner inside
the torch cable assembly preventing it moving
during use and ensures good wire feed.