Torch & Wire Feed Set Up For Aluminium Wire - Unimig VIPER Operating Manual

TORCH & WIRE FEED SET UP FOR
ALUMINIUM WIRE
(1) Remove MIG torch front end parts
(4) Carefully unravel the new liner
(7) Fit the liner collet, liner O-ring and liner
retaining nut.
(2) Remove the liner retaining nut
(5) Carefully feed in the new liner in short
forward movements down the torch lead all the
way to exit the torch neck. Be careful not to kink
the liner
(8) Push the liner firmly into the torch lead and
tighten the liner retaining nut
(3) Carefully pull out and completely remove the
liner
(6) Replace the front end parts
(9) Install a U groove drive roller of the correct
size for the diameter wire being used.
VIPER MIG 185 Manual | 19