Microphone Sensitivity; Silent Baby Monitoring; Night Light - Philips SCD590 User Manual

EngliSh
1
 Release the talk button when you have finished talking.
Note:When you press the talk button, you can no longer hear your baby.

microphone sensitivity

With the sensitivity button on the parent unit you can set the sound that is picked up by the baby
unit to the desired level. When the microphone sensitivity is at maximum level, the baby unit picks
up all sounds (including your baby's breathing, when loud enough).
You can only change the microphone sensitivity if the connection between the baby unit and the
parent unit has been established. This is the case when the connection lights on the parent unit and
the baby unit burn green continuously.
1 Briefly press the sensitivity button on the parent unit. (Fig. 19)
The sound-level lights show the current sensitivity level for approximately 2 seconds.
 Briefly press the volume + and – buttons on the parent unit until the desired microphone
sensitivity for the baby unit has been reached. (Fig. 1)
Note:If you press the sensitivity button and/or the volume + and – buttons too long, the microphone
sensitivity will not be adjusted.
 The sound-level lights show the newly selected sensitivity level for approximately  seconds:
- 1 light burns = minimum sensitivity level
- All 5 lights burn = maximum sensitivity level. At this level, the baby unit is in continuous
transmission mode
Note:When the sensitivity of the baby unit is set to a high level, it picks up more sounds and therefore
transmits more often. As a result, the unit consumes more power.

Silent baby monitoring

1 Briefly press the volume – button on the parent unit until the volume is switched off
completely. (Fig. 0)
The volume is completely switched off when all sound-level lights are out.
As long as the baby unit does not detect a sound, all sound-level lights on the parent unit are
,
out.
When the baby unit detects a sound, the sound-level lights on the parent unit go on.
,
nightlight
1 Briefly press the nightlight button on the baby unit to switch on the nightlight.
 Briefly press the nightlight button again to switch off the nightlight. (Fig. 21)
The nightlight gradually dims before it goes out completely.
 Switch off the night light when operating the baby unit on batteries. This saves power.
Note:If you press the nightlight button too long, the nightlight will not go on or out.
Tip:Do not use the nightlight when you operate the baby unit on batteries. This saves power.
Belt clip and neck strap
If the parent unit is sufficiently charged, you can take it with you inside and outside the house with
the belt clip or neck strap. This allows you to monitor your baby while you are moving around.
Connecting the belt clip
Insert the small pin on the back of the belt clip into the opening on the back of the parent
,
unit (1). Turn the belt clip to the left () until it locks into position ('click'). (Fig. )