Philips SCD590 User Manual page 16

EngliSh
16
Frequently asked questions
This chapter lists the questions most frequently asked about the appliance. If you can't find the
answer to your question, contact the Customer Care Centre in your country.
Question
Why don't the connection
lights burn at all?
Why do the connection
lights burn red while the
parent unit beeps?
Why does the appliance
produce a high-pitched
noise?
Why don't I hear a sound/
Why can't I hear my baby
cry?
Why does the parent unit
react too quickly to other
sounds?
Why does the parent unit
react to baby's crying
slowly?
Why does the battery-low
light on the baby unit and/
or parent unit burn?
Why do the batteries of the
baby unit run low quickly?
Answer
There may be a connection problem. Check if the baby unit is
connected to the mains or if the batteries are inserted properly
and are not empty. Check if the batteries of the parent unit are
properly inserted and still sufficiently charged. If the parent unit is in
the charger, check if the charger is connected to the mains. Also
check if the parent unit and the baby unit are switched on.
The baby unit and the parent unit may be out of range of each
other. Reduce the distance between the units.
The units may be too close to each other. Make sure the parent
unit and the baby unit are at least 1 metre/3 feet away from each
other.
The volume of the parent unit may be set too high. Decrease the
volume of the parent unit.
The volume of the parent unit may be set too low or may be
switched off. Increase the volume of the parent unit.
The microphone sensitivity level may be set too low or may be
switched off. Set the microphone sensitivity level on the parent unit
to a higher level.
The baby unit and the parent unit may be out of range of each
other. Reduce the distance between the units.
The baby unit also picks up other sounds than those of your
baby. Move the baby unit closer to the baby (but observe the
minimum distance of 1 metre/3 feet).
The microphone sensitivity level may be set too high. Decrease the
microphone sensitivity level on the parent unit.
The microphone sensitivity level may be set too low or may be
switched off. Increase the microphone sensitivity level on the
parent unit.
The batteries are running low. Replace the batteries of the baby
unit and/or recharge the batteries of the parent unit.
The microphone sensitivity level on the parent unit may be set too
high, which causes the baby unit to transmit more often. Decrease
the microphone sensitivity level on the parent unit.