Tighten Screws - KTM 250 XC-F 2017 Setup Instructions

3 WORK
3.4 Installing the front fender
3.5 Installing the start number plate
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
Guideline
Screw, front wheel spindle
–
Operate the hand brake lever several times until the brake linings are seated cor-
rectly against the brake disc.
–
Remove the motorcycle from the lift stand. (
–
Operate the front brake and compress the fork a few times firmly.
F00141-11
The fork legs straighten.
–

Tighten screws

Guideline
Screw, fork stub
Main work
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
S01218-10
Finishing work
–
Install the start number plate. (
–
Position the brake line in holders
–
Position the start number plate. Mount and tighten screw
The holding lugs engage in the fender.
S01235-10
2 .
3
.
p. 10)
A
on the start number plate.
M20x1.5 35 Nm
(25.8 lbf ft)
p. 9)
M8 15 Nm
(11.1 lbf ft)
1 2
and .
M6 10 Nm (7.4 lbf ft)
1
.
10