Removals And Replacements - IBM Aptiva 2187 Service Manual

Removals and Replacements

BEFORE REMOVING ANY FRU, POWER-OFF THE COMPUTER
UNPLUG ALL POWER CORDS FROM ELECTRICAL OUTLETS,
THEN DISCONNECT ANY INTERCONNECTING CABLES.
ATTENTION: The System board, processors, adapter cards, DIMMs, and
upgrade processors can be damaged by electrostatic discharge. Use an
electrostatic discharge(ESD) strap to establish personal grounding. If you don't
have an ESD strap, establish personal grounding by touching a ground point
with one hand before touching the static-sensitive FRUs.
The Arrows in the removals and replacements procedures show the direction
of movement to remove a field-replaceable unit(FRU), to turn a screw, or the
direction to press a tab to release the FRU.
Begin all removals by removing the cover (and rear cover, if applicable).
When other FRUs must be removed prior to removing the failing FRU, they
are listed at the top of the page. Go to the removal procedure for each FRU
listed. Remove the FRU, and then continue with the removal of failing FRU.
To replace a FRU, reverse the removal procedure and follow any notes that
Pertain to replacement.
Before disconnecting any cables, note their location and orientation.
Reinstall any new FRUs with cabling in their original location.
4-2