How To Start And Stop Cleaning - LG VR657 Series Owner's Manual

HOW TO START AND STOP CLEANING

Using the Robot Cleaner's Buttons
Once the Robot Cleaner is turned on, press the START/STOP
button on the top of the Robot Cleaner to begin cleaning. A
melody sounds and cleaning begins.
Press the START/STOP button any time during the cleaning cycle
to stop cleaning.
※ To start cleaning when the Robot Cleaner is in standby mode,
press START/STOP once to turn on the power, then press again
to start cleaning.
Using the Remote
Press the Power button on the remote to turn on the Robot
Cleaner.
Once the Robot Cleaner is turned on, press the Start/Stop button
on the remote to start cleaning. A melody sounds and cleaning
begins.
Press the Start/Stop button any time during the cleaning cycle to
stop cleaning.
※ Collisions can occur during cleaning when the sensor cannot detect objects such as thin chair legs,
table legs, or furniture corners. The internal impact detecting sensor reacts by moving the Robot
Cleaner backwards.
※ If the Robot Cleaner is set to start cleaning at a location away from the home station, select a flat
floor clear of obstacles for a starting location to prevent a malfunction of the obstacle detecting
sensor. Curtains and walls must be 12 in. (30 cm) from the Robot Cleaner.
Tip
For best results:
• Briefly scan the area to be cleaned for big and small objects that will cause difficulty for
the Robot Cleaner.
• If cleaning is started when the Robot Cleaner is at the home station, the device
can rapidly be returned to the home station as the current home position has been
accurately read.
• When the mop plate is installed, the Robot Cleaner will not go over door sills or other
obstructions higher than 3/16 in. (5 mm).
19