Advertisement
3
Remote Control Connector
Connect the hush Remote here. Do not connect any other USB-C device or port to this port.
This is only suitable for Yellowtec's hush Remote!
4
Control Ports
The control ports are divided into the groups inputs (GPIs) and outputs (GPOs).
GPIs
RED: A connection to the GND pin switches the RED function active.
WHITE: A connection to the GND pin switches the function WHITE active.
If WHITE and RED are connected to GND at the same time, RED gets priority and the RED function
becomes active.
MUTE : A connection to the GND pin mutes the audio signal of hush + . This input has no function on
the hush
GPOs
If the function RED is active, no matter if triggered by GPI, MIDI event, test button or remote control,
the GPO switches through to GND. This allows e.g. to use a relay to switch a lamp. The GPO is only
switched by the function RED.
Hardware – Rear Panel
9
Advertisement
