Sundance Spas Edison Owner's Manual page 25

4. Activate Jets Pumps
Turn on jets pump(s) to ensure proper mixing when
adding start-up chemicals in step 5.
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Sundance dealer. See Section titled "Water Quality Maintenance"
(page 39) for general guidance.
WARNING:
!
Never leave chemicals opened and accessible to anyone.
Use chemicals according to the vendors instructions. Always
store chemicals in a safe and/or locked location. Keep away
from and out of reach of children.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading no less than 1.0 ppm chlorine
or 2.0 ppm bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
on the inside cover of this manual. If sanitizer levels cannot be
stabilized, perform the decontamination procedure steps 9-15 on the
following page.
Note: The "decontamination procedure" steps 9-15 should also be used
after the spa has been "Winterized" (Section 11.7, page 37) or has
been sitting without power for an extended period.
7. Set Spa To Heat
To warm spa water to a comfortable temperature, follow
these steps:
• The LED display on the control panel displays the actual temperature
of the spa water. Press either the COOLER (
( ) button once to display the "set" temperature for 5 seconds.
If you want the water to heat to a different temperature, simply press
COOLER or WARMER within 5 seconds. The set temperature
increases or decreases by one degree each time one of these
buttons is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
RISK OF POISONING OR DEATH.
680 SERIES
) or WARMER
Page 19