How To Install The Base Using Your Vehicle Seat Belt - Peg-Perego PRIMO VIAGGIO 4-35 NIDO Owner's Manual

How to install the Base using your VEHICLE SEAT BELT

Important! Not all the seat belts work in the same way. To make sure that the car seat is
properly installed using your seat belts, read your Vehicle Owner's Manual. It will suggest
proper installation of a child car seat.
This section refers to base installation using
a common lap/shoulder belt with sliding
latch plate and ELR or SLR retractor (page
18 for additional details).
Make sure that your vehicle is parked on
level ground when you install the base.
Remove the seat from the base following
the procedure at page 27.
Deploy the load leg until it clicks in the
down position and lean the base on the
seat (a). Level the base following the
procedure at page 27.
Position the base rear facing in the back
seat of your vehicle. Check the level
indicator and set the proper angle (b)
following the procedure at page 27.
Keep the latch connectors stored in their
housing. Open the lockoff clip as shown in
the picture (c).
- 32 -