Connection Of The Marking Head To The Ccu; Mounting The Stylus; Adjusting The Height Of The Stylus; Definition Of Operating Distances Of A Stylus - Technifor XF510Cr Operating And Maintenance Manual

4. Connection of the marking head to the CCU

Connect the marking head to the CCU with the appropriate connecting
cable. Tighten the connector all the way without bending the pins.
Once all the elements of this marking equipment have been turned on, the screen
should display the name of the machine connected to the UC. If this is not the case,
contact the distributor immediately.

5. Mounting the stylus

Mounting the stylus

Adjusting the height of the stylus

Adjust the optimum operating distance of the stylus according to the part to be marked.
This distance is between 0.5 mm (0.02 in) and 3 mm (0.118 in).
Remarks
If a stylus is set too high, it doesn't mark because the point doesn't touch the plate consistently while tracing the
characters.

6. Definition of operating distances of a stylus

See styli manual.

7. Using the T05 program

Refer to the user manual for the T05 program.
Ref. DCD01/3074 - XF510Cr-Sr-Dr_en_C
Installation
A
1 : Positioning pin
1
C
23/31