Load Material - Titan CONTROL PRO 190 Owner's Manual

loAD MAtErIAl

These steps will prime the system and get it ready to spray.
i
www.wagnercontrolpro.com/howto
YoU wIll nEED
•
The material you plan to spray
•
Extension cord
•
Waste bucket
recommendation: It is good practice to perform the
i
steps on this page using water to familiarize yourself with
the function of the unit as well as to ensure the unit is set
up properly.
recommendation: Always use new spray material or
i
material that has been thoroughly strained. Old material
often contains debris that can clog the system.
Take care to prevent material spills. Make sure to use drop
cloths or mask anything that is in the spraying area and
could accidentally be sprayed.
Attention
1.
Fully depress the pusher stem to make sure the inlet ball is free.
The pusher stem will only travel approximately 1/8" and
i
will automatically return back to its original position once
released.
2.
Place a full container of spraying material underneath the suction
tube (A). Hold the return tube into a waste container (B).
3.
Turn the PRIME/SPRAY knob to PRIME.
4.
Plug in the sprayer and slowly turn the pressure control knob
clockwise to setting '2'.
Allow pump to run until you see spray material flowing from the
return tube (B).
If you do not see material being drawn up through the
i
suction tube (A) or flowing from the return tube (B), tap the
hose connection (at the pump) with a mallet. If unit still
not drawing material, refer to Troubleshooting, section B.
5.
Switch the pump OFF (0) by turning the pressure control knob
completely counterclockwise.
Place return tube back into material container and clip return tube
and suction tube together.
1
2
3
4
5
En
A
B
A
B
11