Load Material - Titan Advantage Series GPX33 Owner's Manual

2. Load
Material
Start
You will need:
• The material you plan to spray
• Flat blade screwdriver
• Piston Lube™
• Waste bucket
4
(a)
(b)
4. Place a full container
of spraying material
underneath the suction
tube (a).
Hold the return tube into a
waste container (b).
English
1
1. Remove AutoOiler cap with a
flat blade screwdriver.
Squirt Piston Lube into the
AutoOiler. Replace cap.
6
5
5. Turn the PRIME/SPRAY 6. Attach the supplied
knob to PRIME.
2
(a)
2. Push AutoOiler button 2-5 times
to lubricate the fluid section.
Press button 2-3 times before
every use. Be sure to check
reservoir level (a) and refill as
necessary.
7
7. Increase the pressure to
grounding wire to a maximum (+).
grounded object.
Allow pump to run until
Start the engine (see you see spray material
flowing from the return
directions on page 4).
tube.
8
3
3. Fully depress the Sureflo valve
to make sure the inlet ball is
free.
8
8. Shut the engine off. Place
return tube back into
material container and clip
return tube and suction tube
together.