Main Areas Of Application; Application; Coating Materials - WAGNER HEAVYCOAT HC730 Owner's Manual

main areas of application

2
maIN areas of aPPlICaTIoN
2.1

aPPlICaTIoN

The main area of application are thick layers of highly viscous
coating material for large areas and a high consumption of
material.
Priming and final coating of large areas, sealing, impregnation,
construction sanitation, façade protection and renovation, rust
protection and building protection, roof coating, roof sealing,
concrete sanitation, as well as heavy corrosion protection.
examPles of oBJeCTs To Be sPrayeD
Large-scale construction sites, cooling towers, bridges, sewage
treatment plants and terraces.
oPeraTINg TemPeraTure
This equipment will operate correctly in its intended ambient,
at a minimum between +10°C and +40°C.
relaTIVe HumIDITy
The equipment will operate correctly within an environment
at 50% RH, +40°C. Higher RH may be allowed at lower
temperatures.
Measures shall be taken by the Purchaser to avoid the harmful
effects of occasional condensation.
alTITuDe
This equipment will operate correctly up to 2100 m above
mean sea level.
TraNsPorTaTIoN aND sTorage
This equipment will withstand, or has been protected against,
transportation and storage temperatures of -25°C to +55°C and
for short periods up to +70°C.
It has been packaged to prevent damage from the effects of
normal humidity, vibration and shock.
reCommeNDeD Hose CoNfIguraTIoN
Wagner recommends to use the following hose diameters and
lengths:
DN 12 mm, 15 m, connection thread 1/2
DN 6 mm, 60 m, connection thread 1/4
If using a different hose configuration, make sure that the
operating pressure indicated at the pressure gauge is not
above 250 bar. Reduce the pressure if necessary.
8
2.2

CoaTINg maTerIals

ProCessIBle CoaTINg maTerIals
Diluting lacquers and paints or those containing solvents, two-
component coating materials, dispersion and latex paints.
No other materials should be used for spraying without
Wagner's approval.
Pay attention to the Airless quality of the coating
i
materials to be processed.
VIsCosITy
The unit is able to process coating materials with up to 50.000
/ 65.000 mPas. If highly viscous coating materials cannot be
taken in or the performance of the unit is to low, the paint must
be diluted in accordance with the manufacturer's instructions.
Attention: Make sure, when stirring up with
i
motor-driven agitators that no air bubbles are
stirred in. Air bubbles disturb when spraying and
can, in fact, lead to interruption of operation.
CoaTINg maTerIals WITH aBrasIVe maTerIals
These particles have a strong wear and tear effect on valves and
tips, but also on the spray gun. This impairs the durability of
these wearing parts considerably.
TWo-ComPoNeNT CoaTINg maTerIal
The appropriate processing time must be adhered to exactly.
Within this time rinse through and clean the unit meticulously
with the appropriate cleaning agents.
fIlTerINg
Sufficient filtering is required for fault-free operation. The unit
is equipped with a suction filter, an insertion filter in the spray
gun and a high pressure filter on the unit. Regular inspection
of these filters for damage or soiling is urgently recommended.
If using this sprayer with textured materials, it is important that
the filter inside of the spray gun be removed. See section 6.5.
heavycoat