Startup / Operation - BOMANN KS 163.2 Instruction Manual

Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE:
 Ask another person to assist.
You possibly need:

driver as well as a thin-blade screwdriver.
 Remove the screw caps on the device cover,
loosen the screws and remove the device cover.
 Move the blanking cap of the device cover to the
opposite side.
 Dismount the upper door hinge and lift the appli-
ance door.
 Tilt the appliance slightly backwards and block it
in this position. Unscrew the feet and disassemble
the lower door hinge.
 Transfer and fasten the lower door hinge to the
opposite appliance side after unscrewing the
hinge pin and replacing it from the other hinge
side. Screw in the feet.
 Put the appliance back in the upright position.
Put on the appliance door and fix it in its intended
position.
 Transfer and attach the upper door hinge to the
opposite appliance side.
screw wrench, Phillips screw-
 Transfer and attach the upper door hinge to the
opposite appliance side after changing the posi-
tion of the hinge pin holder and the blind plug.
 Attach the device cover and put on the screw
caps again.
Check that the door is optimally aligned both vertical-
ly and horizontally to ensure a smooth opening and
closing of the door.
Reversing the freezer door opening
 Open the freezer door a little. Press the spring of
the lower bracket up slightly with a small screw-
driver and remove the bracket incl. freezer door.
 Place the blind cap (M) at the opposite side.
 Turn the freezer door about 180° and press the
lower door bracket into the appropriated fixture of
the freezer door.
 Lift the freezer door a little and fix it in the upper
door bracket, at the same time you press the low-
er door bracket in the square hole. Small adjust-
ments to the top and bottom will easily the mount-
ing of the door.

Startup / Operation

Prior to first use
CAUTION:
After transport, the appliance should be left standing
upright for four hours before connecting to the power
supply. Nonobservance could lead to malfunction of
the cooling system and causes an appliance break-
down.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
19