Table of Contents
Advertisement
•
Start the coffee maker by switching the ON/OFF switch to position „I". During the
boiling process the red operation control light in the switch will come on.
•
The green heat retention light will come on when the boiling process has completed.
As soon as the brewing process is finished, the temperature is reduced automatically
and the coffee is kept at temperature proper for serving until the power plug is
disconnected from power supply or the ON/OFF switch is set to „O".
NOTE!
To heat the coffee, remove the riser pipe and filter basket. Turn on the device.
The container must contain the amount of coffee for at least 12 cups.
•
Unplug the cord when no liquid flows from the faucet of the standing device.
•
The device is equipped with a heat/boil-dry protection. If the device is accidentally
turned on with little or no liquid, the protection device trips and the device switches
off automatically.
ATTENTION!
In the event that the overheating protection turns on,
disconnect the device from the power source (pull the
plug!) and leave to cool.
Remove the base and press the RESET button on the
bottom of the device quickly several times.
The coffee maker is now ready for use.
Serving coffee
•
Place the cup or glass under the drain valve, press the valve slightly down and hold
until the cup is filled with required amount of coffee.
•
Release the drain valve which is closed automatically.
•
In order to obtain full flow press the valve lever fully down.
NOTE!
The drain valve is located a little higher, therefore the dregs remain on the water
tank bottom and do not enter the served coffee.
•
When the device is placed in normal position and the coffee does not flow, remove
the plug and fill the device with fresh water after cooling down, when required.
- 30 -
Advertisement
Table of Contents
