CONNECTING A TANK TO A WATER AND HEATING SYSTEM
OKC 80 - 200 NTR/Z
CONNECTION OF INDIRECT TANK TO HOT WATER SYSTEM
It is recommended to install stop valves on the heating water inlet and outlet (for possible
dismantling of the heater). Valves should be as close as possible to the tank to minimize heat
losses.
When the tank is connected to water supply system, hot water heating system or power supply,
and after the safety valve is tested (accordingly with the manual attached to the valve),
the heater can be put in operation. Before opening the power supply, the tank must be filled
with water. The process of first heating must be executed by licensed professional who has to
check it. Both the hot water outlet pipe and safety armature parts may be hot.
Figure 17
The water installation must follow and
meet the requirements and regulations
relevant in the country of use!
- 25 -