NordicTrack NTL16915.4 User Manual page 22

8. Turn on the fan if desired.
The fan features multiple speed settings and an
auto mode. When the auto mode is selected,
the speed of the fan will automatically increase
and decrease as the speed of the walking belt
increases and decreases.
Press the fan buttons repeat-
edly to select a fan speed or
the auto mode, or to turn off
the fan.
9. When you are fi nished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to zero. The
incline must be at zero or you may damage the
treadmill when you fold it to the storage posi-
tion. Next, remove the key from the console and
put it in a secure place.
When you are fi nished using the treadmill, press
the power switch into the off position and unplug
the power cord. IMPORTANT: If you do not do
this, the treadmill's electrical components may
wear prematurely.
HOW TO USE AN ONBOARD WORKOUT
1. Insert the key into the console.
See HOW TO TURN ON THE POWER on page 20.
2. Enter your weight.
See step 3 on page 20.
3. Select an onboard workout.
To select an onboard workout, press the Incline
button, the Intensity button, or the Speed button
repeatedly until the desired workout appears in the
display.
When you select an onboard workout, the display
will show the duration of the workout.
4. Start the workout.
Press the Start button. A moment after you press
the button, the treadmill will automatically adjust to
the fi rst speed and incline settings of the workout.
Hold the handrails and begin walking.
Each workout is divided into segments. One speed
setting and one incline setting are programmed
for each segment. Note: The same speed setting
and/or incline setting may be programmed for con-
secutive segments.
At the end of each segment, if a different speed
and/or incline setting is programmed for the next
segment, the treadmill will automatically adjust to
the speed and incline settings for the next seg-
ment.
If the speed or incline setting is too high or too low
at any time during the workout, you can manu-
ally override the setting by pressing the Speed or
Incline buttons; however, when the next segment
of the workout begins, the treadmill will auto-
matically adjust to the speed and incline set-
tings for the next segment.
To stop the workout at any time, press the Stop
button. To resume the workout, press the Start but-
ton. The walking belt will begin to move at 1 mph.
When the next segment of the workout begins, the
treadmill will automatically adjust to the speed and
incline settings for the next segment.
22