Serial connector module
Follow these steps to remove the serial connector module:
1.
Prepare the computer for disassembly (see
2.
Remove the access panel (see
a.
Front bezel (see
b.
Drive cage (see
c.
Shroud (see
Remove the serial connector module:
1.
Disconnect the serial connector module cable (1)from the system board.
2.
Remove the two 3/16-in. screw locks (2)that secure the serial connector module to the computer chassis.
3.
Remove the serial connector module (3).
Reverse this procedure to install the serial connector module.
Access panel on page
Front bezel on page
34)
Drive cage on page
35)
Fan shroud on page
43)
Preparation for disassembly on page
32), and then remove the following components:
31).
Serial connector module
47