Power Supply - HP ProDesk 400 G5 SFF Maintenance And Service Manual

Power supply

Follow these steps to remove the power supply:
1. Prepare the computer for disassembly (see
2. Remove the access panel (see
3. Remove the front bezel (see
4. Remove the drive cage (see
Remove the power supply:
1. Position the computer with the rear panel toward you.
2. Disconnect the power supply P1 (1), P2 (2), and P3 (3)cables from the system board.
3. Release the power supply P3 cable from the retention clips built into the fan shroud (4).
4. Remove the four Torx-15 M3.0×9.0 screws (5)that secure the power supply to the computer chassis.
5. Press down on the power supply release tab (6).
6. Slide the power supply forward (7), and then remove the power supply.
Reverse this procedure to install the power supply.
42 Chapter 4 Removal and replacement procedures
Preparation for disassembly on page
Access panel on page 32).
Front bezel on page 34).
Drive cage on page 35).
31).