Set Minimum Height; Set Maximum Height; Error Codes - LifeSpan Workplace SD9 Owner's Manual

Set Minimum Height

While holding down the M and 1 key the display will blink while still showing the
current height. Press the
desired height. Press M + 1 to complete the setting.

Set Maximum Height

While holding down the M and 2 key the display will blink while still showing the
current height. Press the
desired height. Press M + 2 to complete the setting.

Error Codes

Error Code
HOT
E01
E02
and buttons to adjust the desk to the minimum
and buttons to adjust the desk to the maximum
Description
Overheat- System
detects the action by not
following the rated duty
cycle and prevents it
from overheating.
The cable of motor 1 is
not connected
The cable of motor 2 is
not connected
SD9 Desk Operations
Handling Steps
Stop operating
until cooled off.
1.Check whether the
cable of motor 1, or
motor 2 is properly
connected to the motor
control unit.
2. Check that the cable
of motor 1, or motor 2
is intact.
3. After trouble shoot-
ing, press any key
clear the error code to
resume running (except
M key)
23