Table of Contents
Advertisement
PXIe-5764 CLIP
The PXIe-5764 CLIP provides access to four AC- or DC-coupled analog input channels.
In the LabVIEW FPGA Module, 16-bit analog input data is accessed using an I16 data type.
The DIO signals are grouped into two ports of four signals each and are accessed using a U8
data type and a Boolean write enable signal.
Making a Measurement
Making a Measurement with LabVIEW
1.
Launch LabVIEW.
2.
Select Help»Find Example.
3.
Open the example VI that you want to use by selecting Hardware Input and Output»
FlexRIO.
4.
Follow any setup, configuration, and execution instructions in the VI.
Troubleshooting
If an issue persists after you complete a troubleshooting procedure, contact NI technical
support or visit ni.com/support.
What Should I Do if the PXIe-5764 Doesn't Appear in
MAX?
1.
In the MAX configuration tree, expand Devices and Interfaces.
2.
Expand the Chassis tree to see the list of installed hardware, and press <F5> to refresh
the list.
3.
If the module is still not listed, power off the system, ensure that all hardware is correctly
installed, and restart the system.
4.
Navigate to the Device Manager.
Operating System
Windows 10/8.1
Windows 7
5.
Verify the PXIe-5764 appears in the Device Manager.
a)
Under an NI entry, confirm that a PXIe-5764 entry appears.
b)
If error conditions appear, reinstall FlexRIO Support and the PXIe-5764.
12 | ni.com | PXIe-5764 Getting Started Guide
Description
Right-click the Start button, and select Device Manager.
Select Start»Control Panel»Device Manager.
If you are using a PC with a device for PXI remote control system,
Note
under System Devices, also confirm that no error conditions appear for the
PCI-to-PCI Bridge.
Advertisement
Table of Contents
