Table of Contents
Advertisement
3. Assemble the Control Head Base
Your control head base will have a tilt and swivel mount. See the instructions
below to assemble and mount the control head base.
Tilt and Swivel Mount
Control Head Base Assembly
Countersink
Side Out
Arm Screws,
(4) #6 x 7/16"
Figure 5
Fixed Control Head Installation
Assemble the Tilt and Swivel Mount
1. Insert the mount arms into the
Mount Arms
2. Insert the swivel ring into the base,
Base
3. Secure the mount arms with the
Swivel
Ring
4. Set the assembled control head
5. Set the base aside, and drill the
6. Proceed to Route the Control Head
base. Then, hold the mount arms in
place as you turn the base upside
down.
with the countersink holes for the
arm screws facing out.
four #6 screws provided (Figure 5).
Hand tighten only!
base in place on the selected
mounting surface. Mark the four
mounting screw locations with a
pencil or punch.
four mounting screw holes using a
9/64" (3.6 mm) bit.
Cables Under the Deck.
4
Advertisement
Table of Contents
