Table of Contents
Advertisement
5. Adjust the initial angle of the transducer from back to front by rotating
the transducer until the side seam on the transducer is almost parallel
with the bottom of the boat, one click at a time in either direction
(Figure 21 and 22).
Figure 21
Figure 21
Adjusting the Initial Transducer Angle (XNT 9 28 T)
Leading edge
Figure 22
Adjusting the Initial Transducer Angle (XNT 9 DI T)
Leading edge
Figure 22
15
One click too high
Correctly aligned
(transducer side
seam aligned
with boat bottom)
Trailing edge
One click too low
One click too high
Correctly aligned
(transducer side
seam aligned
with boat bottom)
Trailing edge
One click
too low
Transom Transducer Installation
Advertisement
Table of Contents
