Table of Contents
Advertisement
Read and follow the steps below to play a tape.
1
Turn on the TV and set it to channel 3 or 4 (the
VCR's RF output channel). (Press and hold PLAY during
tape play for three seconds to switch the VCR's RF output
channel to 3 or 4. Channel 3 is the default setting.)
2
Insert a tape in the VCR. The POWER,VCR/TV, and
CST.IN lights will appear. If the tape's record tab has been
removed, play will begin automatically.
3
If play does not start automatically, press PLAY.
4
Press STOP to stop play.
5
Press REW to rewind the tape.
6
Press EJECT to remove the tape.
Playing 23
1
Turn on the TV.
2
Insert a tape.
POWER
VCR/TV
EJECT
5
PLAY
4
REW
STOP
STATUS
1
2
3
4
5
6
7
8
9
0
SPEED
SEARCH MODE STILL/PAUSE
REC
MEMORY
SLOW
Helpful Hints
• If the tape you want to play is in
the VCR, make sure the VCR
power is on and the VCR is in VCR
position. (Press VCR/TV so the
VCR/TV light appears.) Press PLAY.
• Other playback options and fea-
tures are on pages 33-41.
• If AUTO REPEAT is ON, play will
begin automatically, even when
the record tab is intact. See page
33.
• If you used audio and video cables
to connect the VCR to the TV as
shown on page 10, set the TV to
its Video In or Auxiliary In channel
instead. See your TV manual for
details.
6
3
F.FWD
CH
Advertisement
Table of Contents
