Advertisement
EEI–2805/2806
Thank you for purchasing the MODWAY TABLE!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
Component:
3
1
Table Glass
x1
Customer Service 908-368-1025︱www.modwayfurniture.com
TABLE
1
2
3
2
Table Top
Hardware:
A
B
C
D
E
F
3
x1
Double-End Bolt
Nut 1/4"
Spring Washer 1/4"
Flat Washer 1/4"
Wrench 1/4"
Plastic Cover
3
3
Table Leg
Page 1 of 4
x 4
x 8
x 8
x 8
x 1
x 4
x4
Advertisement
Table of Contents
Related Manuals for modway EEI 2806
Summary of Contents for modway EEI 2806
- Page 1 EEI–2805/2806 TABLE Thank you for purchasing the MODWAY TABLE! Before you start, here are some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI–2805/2806 TABLE STEP 1: Secure 1 piece of Nut (B) into one end of Double-end Bolt (A) by hand as shown. Repeat the same steps for the remaining Double-end Bolts (A). Hardware & Tool required STEP 2: Please put Table Top (2) upside down on a carpeted or padded area. Secure 4 pieces of Double-End Bolt (A) into the bottom of Table Top (2) as shown.
- Page 3 EEI–2805/2806 TABLE STEP 3: Put 4 pieces of Table Leg (3) to Table Top (2) through the assembled Double-End Bolt (A) as shown. STEP 4: Secure 4 pieces of Nut (B), 4 piece of Spring Washer (C), and 4 pieces of Flat Washer (D) to the end of assembled Double-End Bolt (A) as shown.
- Page 4 EEI–2805/2806 TABLE STEP 5: Insert 4 pieces of Plastic Cover (F) into the assembled Table Leg (3) as shown. Hardware & Tool required STEP 6: Carefully turn over the assembled table. Put Table Glass (1) to the Table Top (2) as shown. Assembly is complete.
Need help?
Do you have a question about the EEI 2806 and is the answer not in the manual?
Questions and answers