modway EEI–2815 Quick Start Manual

modway EEI–2815 Quick Start Manual

Bar stool

Advertisement

EEI –2815/2816
Thank you for purchasing the MODWAY BARSTOOL!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the barstool, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.

Components:

1
Barstool Back
Customer Service 908-368-1025︱www.modwayfurniture.com
BAR STOOL
1
2
x1

Hardware:

A
B
C
D
Bolt M6x14mm
x 4
Nut
M6
x 4
Wrench M6
x 1
Allen Wrench M4 x 1
2
Barstool Base
x1
Page 1 of 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EEI–2815 and is the answer not in the manual?

Questions and answers

Summary of Contents for modway EEI–2815

  • Page 1 EEI –2815/2816 BAR STOOL Thank you for purchasing the MODWAY BARSTOOL! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2.Owing to the size and weight of the barstool, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
  • Page 2 EEI –2815/2816 BAR STOOL STEP 1: Put Barstool Base (2) on a carpeted or padded area. Attach Barstool Base (2) to Barstool Back (1) by using 4 pieces of Bolt (A) and 4 pieces of Nut (B) as shown. Use Wrench (C) and Allen Wrench (D) to tighten the Bolts (A) and Nut (B) until secure. Hardware &...

This manual is also suitable for:

Eei–2816

Table of Contents