modway EEI-2859 Manual

Office chair

EEI-2859

OFFICE CHAIR

Thank you for purchasing the MODWAY OFFICE CHAIR!

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step

instructions.

2.Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or instructions until you have checked all the components

and hardware and the furniture is fully assembled.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten

the components from time to time, so please save the tools that have been provided.

6.Please keep all pieces out of reach of children.

A Chair Body x1

E Cylinder x1

Customer Service 908-368-1025︱www.modwayfurniture.com

Hardware:

B Armrest x2

C Decoration Cover x 1

G Castor x5

F Chair Base x1

Bolt M8*15

Flat Washer

Allen Wrench M6

D Control Mechanism x1

Page 1 of 3

Table of Contents

Do you have a question about the EEI-2859 and is the answer not in the manual?

Page 1 EEI-2859 OFFICE CHAIR Thank you for purchasing the MODWAY OFFICE CHAIR! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2.Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 EEI-2859 OFFICE CHAIR STEP 1: Please put Chair Base (F) upside down on a carpeted or padded surface. Insert 1 piece of Castor (G) into the Chair Base (F) by hand as shown . Repeat the same steps for the remaining 4 pieces of Castors (G).
Page 3 EEI-2859 OFFICE CHAIR STEP 3: Attach Control Mechanism (D) to the Chair Seat (C) by using 4 pieces of Bolts (1) with 4 pieces of Flat Washers (2) as shown. Tighten Bolts (1) by using Allen Wrench M6(3) as shown.

Groove eei-2859-gry