Advertisement
EEI–2799/2800
Thank you for purchasing the MODWAY BAR STOOL!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bar stool, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Components:
1
Bar Stool Back
x1
4
Stretcher
x2
Customer Service 908-368-1025︱www.modwayfurniture.com
BAR STOOL
2
4
2
Bar Stool Seat
EEI-1006 Seat Cushion (Packed separately)
5
Hardware:
A
B
C
D
1
5
3
4
x1
Short Bolt x20mm
x 8
Long Bolt x40mm
x 8
Flat Washer
x 16
Allen Wrench
x 1
3
Bar Stool Front
Page 1 of 4
x1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for modway Conduit EEI-2799
Summary of Contents for modway Conduit EEI-2799
- Page 1 EEI–2799/2800 BAR STOOL Thank you for purchasing the MODWAY BAR STOOL! Before you start, here are some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the bar stool, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI–2799/2800 BAR STOOL STEP 1: Please put Bar Stool Back (1) on a carpeted or padded area. Place Bar Stool Seat (2) to Bar Stool Back (1) as shown. Insert 4 pieces of Long Bolt (B) with 4 pieces of Flat Washer (C) into the holes on Bar Stool Back (1) through the holes on Bar Stool Seat (2) .
- Page 3 EEI–2799/2800 BAR STOOL STEP 3: Put Bar Stool Front (3) to the assembled Bar Stool Back (1) , Bar Stool Seat (2) , and Stretchers (4) as shown. Insert 4 pieces of Long Bolt (B) with 4 pieces of Flat Washer (C) into the holes on Bar Stool Front (3) through the holes on Bar Stool Seat (2) .
- Page 4 EEI–2799/2800 BAR STOOL STEP 5: Carefully put Seat Cushion (5) to Bar Stool Seat (2). . Fasten Seat Cushion (5) to Bar Stool Seat (2) by using the band on Seat Cushion (5) as shown. Band on Seat Cushion (5) Customer Service 908-368-1025︱www.modwayfurniture.com Page 4 of 4...
Need help?
Do you have a question about the Conduit EEI-2799 and is the answer not in the manual?
Questions and answers