Bellfires Smart Bell 75/55 MF User Manual page 19

Action
Start the light
Stop the light
Decrease the light
brightness
Increase the light
brightness
Table 6: Set the fan speed (option)
Smart Bell 75-55
Preconditions
Possible when the fire
is on or off.
The light symbol is on. •
The light symbol is on. •
Note: The convection fan turns automatically ON and OFF and has 4 rotational speeds
which can be adjusted from low (1 bar) to high (4 bars).
Note:
• ON: The convection fan will automatically turn ON about 4 minutes after the main
burner is ignited, on maximum fan speed and after 10 seconds will revert to the set
fan speed.
• OFF: It is not possible to switch the convection fan OFF while the main burner is
on. The convection fan turns OFF automatically about 10 minutes after the main
burner has been turned off. (The microswitch on the gas regulator block is now
switched on!). The pilot light can continue burning or be turned off.
Caution:
Ensure that the convection fan does not run constantly and never switches off. If the
main burner is not switched off completely, (the microswitch on the gas regulator block
has not come on yet!) the convection fan will continue to run and will NOT switch off!
This can occur if the main burner is extinguished by the thermostat or is not completely
switched off manually.
Steps Result
Push
Push
Push and hold
until the
light symbol flash-
es
• Push and hold
until you
have the desired
light brightness
Push and hold
until the
light symbol flash-
es
• Push and hold
until you
have the desired
light brightness
Operation
19