Newa More NMO 20 CRNE Instructions And Warranty page 33

EXAMPLE (Fig.34) :
If you want the aquarium lights to turn on every day at 8am and turn off at 7pm, the total duration of the daytime phase
(including 40' for the sunrise phase and 40' for the sunset phase) needs to be increased by 3 hours with respect to the daytime
phase of the preset program, for a total of 11 hours of duration of the daytime phase. The night-time phase will be automatically
reduced to 13 hours, covering the 24 hours daily.
In this case, proceed as follows:
• Start the programming at 8am;
• Access the programming function by pressing the keys
• Press the "+1h" key 3 times to increase the duration of the daytime phase, preset to 8 hours in the program by the
manufacturer.
• Do not press any key for more than 15 seconds to exit the programming phase.
• The LEDs will flash for a number of times equal to how many hours the lights will be on during the day.
• The LEDs will start the program of the daytime phase.
WARNING: with each new programming, the previous program will be deleted. The new programming will be
based on the preset program of the manufacturer (8 hours daytime phase and 16 hours night-time phase).
Dimmer operation (Fig.35):
The LED strips fitted in NEWA MORE aquariums are equipped with a dimmer that allows you to customise the brightness of the
light emitted both during the daytime phase and during the night-time phase.
In particular, remember that it is possible to change:
• the brightness level during the daytime phase from 15% to 100%;
• the brightness level during the night-time phase from 0 to 15%.
• IT IS NOT POSSIBLE TO CHANGE THE BRIGHTNESS during the sunrise phase or during the sunset phase. This is
because both the duration of each phase (40 minutes) and the brightness are managed automatically by the preset program.
To change the brightness of each phase, simply press the
Therefore:
• During the daytime phase, press the
At the first continuous press, the brightness will be reduced gradually from 100% to 15% (minimum limit for the daytime phase).
• It is possible to block the brightness setting at any time by releasing the
The selection will be saved automatically and maintained over time until new programming or in the event of a power failure
lasting more than 40 minutes.
• It is possible to change the saved setting by pressing the
WARNING: Starting from the basic settings, press the
increase it.
• When the minimum set level (15%) or the maximum set level (100%) has been reached, the LEDs will flash.
Do the same to change the brightness of the night-time phase (max 15% - min 0%).
Manual power on/off of the LED strip:
If necessary, it is possible to turn the lights of the LED strip on or off using the
programmed.
In particular, the key :
• Turns on the LED lights at their maximum power if they are off, or at any previously programmed brightness during the
night-time phase;
• Turns off the LED lights if turned on manually, or at any previously programmed brightness during the daytime phase;
• Turns on the lights at their maximum brightness or turns them off during the sunrise or sunset phases
+ together for about 2 seconds
key during the specific phase.
key to change the basic settings (brightness 100%).
key again.
key once to reduce the brightness; press it again to
33
;
key.
key, which always has priority over what is
UK