Maintenance, Service, And Storage - 3M DBI Sala 3400800C Instruction Manual

6.0 MAINTENANCE, SERVICE, and STORAGE

6.1 CLEANING: Cleaning procedures for the Self-Retracting Device are as follows:
• Periodically clean the exterior of the SRD using water and a mild soap solution. Position the SRD so excess water can
drain out. Clean labels as required.
• Clean lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry with heat. An
excessive buildup of dirt, paint, etc. may prevent the lifeline from fully retracting back into the housing causing a
potential free fall hazard. Replace lifeline if excessive buildup is present.
6.2 SERVICE: Additional service, determined from the Competent Person inspection, must be completed by an authorized
service center. Do not attempt to disassemble the SRD or lubricate any parts.
6.3 STORAGE AND TRANSPORT: Store and transport Self-Retracting Device in a cool, dry, clean environment out of direct
sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the SRD after any period of extended storage.
7.0 Labels
Figure 20 illustrates labels on the the Sealed-Blok SRDs and their locations. All label must be present on the SRD. Labels
must be replaced if they are not fully legible. Information provided on each label is as follows:
Read all instructions.
Length of Lifeline (Maximum Lifting Distance)
A1 A2
A) Serial Number B) Model Number C) Date Manufactured D) Lot Number E) Service Dates
D
This product is Radio Frequency Identification (RFID) enabled and contains an electronic tag that can be read by
E
compatible readers - providing inspection logs, inventory management, and other safety information.
To Lower: Rotate the Crank Arm clockwise. To Raise: Rotate the Crank Arm counterclockwise.
F
G Retrieval Operation:
Knob. Push the Crank in and release the Shift Knob. If needed, rotate the Crank Arm clockwise slightly to engage
D
the gear. Rotate Crank Arm counterclockwise to lift. Rotate Crank Arm clockwise to lower.
Crank Arm.
Loosen Locking Thumbscrew.
A
Rotate the Retrieval Handle up.
B
14
Pull and hold the Shift
C
Release Shift Knob to lock
E