Select Welding Task; Welding Data Display - EWM Tetrix 351 Smart FW Operating Instructions Manual

5.8.3

Select welding task

No changes can be made to the basic welding parameters during the welding process.
The welding task is selected using the buttons on the machine control on the welding machine.
Signal lights (LED) display the welding parameter selection.
Set the welding task in the following order:
Symbol Description
Welding process button
Operating mode button
TIG pulse welding
Select welding parameters button
This button is used to select the welding parameters depending on the welding process and
operating mode used.
Welding parameter setting rotary transducer
Setting flows, times and parameters.
5.8.3.1

Welding data display

The following welding parameters can be displayed before (nominal values) or during (actual values)
welding.
Parameter
Welding current
Parameter times
Parameter currents
099-000128-EW501
16.07.2014
0
MMA welding
TIG welding
spotArc (spot time setting range 0.01 sec. to 20.0 sec.)
Non-latched
Latched
TIG automated pulses (frequency and balance)
Before welding (nominal values)



Design and function
NOTE
During welding (actual values)
TIG welding

-
-
35