Bobbin Holder For Embroidery (High Tension); Embroidery Hoops - ELNA Creative Series Instruction Book

z
x
t
q
e
q
w
r
e
w
r
t

Bobbin Holder for Embroidery (high tension)

CAUTION:
Always make sure to press the lockout key to lockout
the machine or turn the power switch off before
attaching the bobbin holder.
Replace the standard bobbin holder (part number
846652504) with the special bobbin holder (high tension,
part number 846652607) when using bobbin threads
other than bobbin thread for embroidery.
Either part number (846652504 or 846652607) is
indicated inside the bobbin holder.
q Part number indicated here
z Remove the needle, embroidery foot and needle plate
(refer to the pages 14, 16 and 64).
Take out the standard bobbin holder.
w Standard bobbin holder
x Insert the special bobbin holder into the hook race.
Make sure to match the knob of the bobbin holder with
the stopper on the machine.
Attach the needle plate, presser foot and needle.
e Knob
r Stopper
t Special bobbin holder for embroidery
(high tension)
NOTE:
Use the standard bobbin holder when sewing quilting
designs that use the same thread for the bobbin as
the needle thread.

Embroidery Hoops

q Embroidery hoop SQ14b
A square embroidery hoop with a 14 cm (5.5˝) square
embroidery area.
w Embroidery hoop RE20b
An extra large embroidery hoop with a 14 cm by 20 cm
(5.5˝ by 7.9˝) embroidery area.
e Embroidery hoop SQ20b
A square embroidery hoop with a 20 cm (7.9˝) square
embroidery area.
r Embroidery hoop RE36b
An extra large embroidery hoop with a 20 cm by 36 cm
(7.9˝ by 14˝) embroidery area.
t Clamp (RE20b, SQ20b and RE36b)
A clamp for holding the fabric to the embroidery hoops
RE20b, SQ20b and RE36b.
* The embroidery hoops supplied with your machine vary
depending on your model.
17