Care And Maintenance; Cleaning The Hook Area - ELNA Creative Series Instruction Book

q
w
t

CARE AND MAINTENANCE

Cleaning the Hook Area

Clean the hook area at least once a month.
The caution message for cleaning the bobbin case and
the hook race will be displayed after a certain period if
the clean bobbin holder message option is turned on (refer
to page 56).
Turn the power switch off and unplug the machine.
Remove the needle plate by turning the setscrews with
the screwdriver key.
Remove the needle and presser foot.
e
Take out the bobbin and bobbin holder.
Clean the bobbin holder with a lint brush.
r
Apply a few drops of the bobbin holder cleaner (included
in the standard accessories) to a soft cloth and wipe the
bobbin holder thoroughly both inside and outside.
Clean the auto thread cutter device with the lint brush.
Clean the inside and lip of the hook race with a soft cloth.
Insert the bobbin holder so that the knob fits next to the
y
stopper in the hook race.
Insert the bobbin.
Attach the needle plate, presser foot and needle.
u
64
WARNING:
• Turn the power switch off and unplug the machine
before cleaning.
• Do not dismantle the machine in any way other than
as explained in this section.
CAUTION:
• Do not store the machine in a high-humidity area,
near a heat radiator, or in direct sunlight. Store the
machine in cool dry place.
• Clean the outside of the machine with a soft cloth.
• Do not use chemical solvents.
q Bobbin holder
w Lint brush
e Bobbin holder cleaner
r Soft cloth
t Auto thread cutter device
y Knob
u Stopper