ELNA Creative Series Instruction Book page 70

r
q
e
Oil the lower shaft supporter (front)
Remove the cap q and setscrew A w with a screwdriver.
Stand the machine so that the handwheel side comes to
the underside of the machine.
w
Insert the screwdriver from the bottom hole of the thread
cutter cover. Loosen the setscrew B e.
Remove the thread cutter cover r.
q Cap
w Setscrew A
e Setscrew B
r Thread cutter cover
Oil the arrow point (felt) as indicated in the illustration.
Oil the lower shaft supporter (rear)
Stand the machine so that the handwheel side comes to
the underside of the machine.
Remove the cover q on the underside of the machine
with a screwdriver.
q Cover
q
Oil the arrow point (felt) as indicated in the illustration.
68
NOTE:
Be careful not to damage any parts when raising the
machine.
NOTE:
Be careful not to damage any parts when raise the
machine.