KTM 350 SX F 2017 Owner's Manual page 96

17 SERVICE WORK ON THE ENGINE
–
Remove screws
S01274-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
S01275-10
– Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter with engine oil and position the oil filter in the housing.
–
Oil the O-ring of the oil filter cover and mount it with oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
–
Stand the motorcycle upright.
S01274-11
–
Remove filler plug
oil.
Engine oil
401955-12
Info
Too little engine oil or poor-quality engine oil results in premature wear of
the engine.
–
Install and tighten the oil filler plug with O-ring.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and death.
–
–
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the engine oil level. (
5
. Remove the oil filter cover with the O-ring.
6
out of the oil filter housing.
8
with the O-ring from the clutch cover and fill up with engine
1.0 l (1.1 qt.)
Always make sure there is sufficient ventilation when running the
engine.
Use an effective exhaust extraction system when starting or running the
engine in an enclosed space.
p. 92)
7
M6 10 Nm (7.4 lbf ft)
Engine oil (SAE 10W/50) (
Alternative engine Engine oil
oil for harsh oper- (SAE 10W/60)
ating conditions (00062010035)
and increased per- ( p. 109)
formance
94
.
p. 109)