11
SERVICE WORK ON THE CHASSIS
–
Position the upper triple clamp with the handlebar.
–
Mount screw
S01213-10
–
Position the fork legs.
Bleeder screw
Valve
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
The air suspension is located in the left fork leg. The pressure and rebound
H01182-11
damping is located in the right fork leg.
–
Tighten screws
Guideline
Screw, bottom triple clamp
S01214-10
–
Tighten screw
Guideline
Screw, top steering head
S01215-10
–
Mount and tighten screw
Guideline
Screw, top steering stem
S01216-10
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid stresses.
–
Tighten screws
Guideline
Screw, top triple clamp
–
Secure the wiring harness with cable holder
–
Mount the holder with FI warning lamp.
Guideline
S01214-11
Remaining nuts, chassis
4
but do not tighten yet.
5
of the right fork leg is positioned to the front.
A
of the left fork leg faces the front.
6
.
4
.
7
.
M8
8
.
M8
12 Nm (8.9 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
Loctite
20 Nm
(14.8 lbf ft)
M8
17 Nm
(12.5 lbf ft)
9
on the left.
M6
10 Nm (7.4 lbf ft)
42
243™
®