Advertisement
Dark Green Wire: ( - ) Instant Trigger Zone
This is an instant on ground trigger wire. It must be connected to the optional previously installed hood and
trunk pin switches when used.
Brown Wire: - Door Trigger
If the vehicle's courtesy light switches have a ( - ) ground output when the door is opened (GM and most
Imports), you must connect this wire to the negative output from one of the door switches.
WARNING: Do not use the brown wire if the vehicle has + 12 volt output type door switches.
(See Purple Wire). Note for vehicles with interior delay lighting see programming under title
Completing The Installation".
Purple Wire: + Door Trigger
If the vehicle's door courtesy light switches have a + 12 volt output when the door is opened (most Fords
and some Imports), you must connect this wire to the positive output from one of the door switches.
WARNING: Do not use the purple wire if the vehicle has ground output type door switches.
( see Brown Wire ). Note for vehicles with interior delay lighting see programming under title
"Completing The Installation".
Yellow Wire: + 12 VDC Ignition Source
Connect this wire to a source that is live when the key is in the on and crank positions. Be sure that this
source is off when the key is in the off position.
White w/ Blue Trace Wire: Low Current (-) Ground Headlight Output
The White w/ Blue Trace wire is provided to operate the optional headlamp illumination feature of the
system. This is a low current (300mA) output and must be connected to an external relay to control the
high current switching circuit of the vehicle's headlamps. To use this option, Connect the White /w Blue
Trace wire to terminal # 86 of a P&B VF45F11 relay or equivalent. Connect Terminals #85 and # 30 to a
fused + 12 Volts source with a current capability equal to or in excess of the factory headlamp fuse.
Connect terminal # 87 of the relay to the switched + 12 volt wire feeding the vehicle's headlamp circuit.
NOTE:
For ground switched headlamp circuits, Connect the White /w Blue Trace wire to terminal # 86
of a P&B VF45F11 relay or equivalent. Connect Terminal #85 to a fused + 12 Volts source.
Connect terminal # 30 to a clean chassis ground. Connect terminal # 87 to the ground switched
headlamp control wire in the vehicle.
Light Green Wire: (-) Instant Trigger Zone 1
This is a instant on ground trigger input intended for the connection of optional triggering devices. The
ground trigger output wire of motion detectors, microwave detectors, or glass break detectors, can be
connected to this Light Green trigger input wire.
Light Blue/Green Wire: Delayed 300 mA Pulsed Output / Channel 5
The light blue/green wire pulses to ground via an independent RF channel from the keychain transmitter.
This is a transistorized, low current output, and should only be used to drive an external relay coil.
Page 7
128-8806b
7 of 12
Advertisement
