Table of Contents
Advertisement
Chapter 2
Installing Device
1
1
Figure 4: Panel Mounting
1. Screw
2. Panel/DIN Rail Adapter
2.
Install the supplied screws to secure the adapters to the panel.
Section 2.2
Connecting Power
The RS1600F supports single or dual redundant high AC, high DC and/or low DC power supplies. The use of two
power modules is recommended to provide redundancy and load balancing.
The RS1600F can be equipped with either a screw-type or pluggable terminal block, which provides power
to both power supplies. The screw-type terminal block is installed using Philips screws and compression
plates, allowing either bare wire connections or crimped terminal lugs. Use #6 size ring lugs for secure, reliable
connections under severe shock or vibration.
IMPORTANT!
• For maximum redundancy in a dual power supply configuration, use two independent power
sources.
• For 100-240 VAC rated equipment, an appropriately rated AC circuit breaker must be installed.
• For 88-300 VDC rated equipment, an appropriately rated DC circuit breaker must be installed.
• Use only #16 gage wiring when connecting terminal blocks.
• A circuit breaker is not required for 12, 24 or 48 VDC rated power supplies.
• It is recommended to provide a separate circuit breaker for each power supply module.
8
RUGGEDCOM RS1600F
Installation Guide
2
Connecting Power
Advertisement
Table of Contents
