Table of Contents
Advertisement
Welcome!
Thank you for purchasing this NVR.
This guide is designed to be a quick reference for installing the system.
Please read this guide carefully before installing and operating the unit.
For more detailed information, please refer to the user manual.
If technical assistance is needed, please contact Speco Technologies Technical Support.
Phone: 1-800-645-5516 option 3
Email:
techsupport@specotech.com
Important Safeguards and Warnings
Speco Technologies assumes no liability or responsibility for any fires or electrical shock caused by improper
handling or installation.
Speco Technologies is not liable for any problems caused by unauthorized modifications or attempted repair.
Note: All of the installation and operations here should conform to your local electric safety rules.
1.
Contents
1.1 Check Unit and Accessories
After unpacking the unit, please check for any visible damage. Then check to make sure that all accessories are included.
Check that the model number and serial number that's listed on the label on the unit are the same as what's listed on
the package label.
1.2 Connections
To quickly get started, connect the following to your recorder in the following order, please refer to Figure 1-2.
1.
Connect a monitor to the recorder via VGA or HDMI cable (not included).
2.
Connect the included optical mouse into any USB port of the recorder.
3.
Connect the power adapter to the recorder and plug power cord into a 120VAC 50/60Hz outlet.
4.
Connect recorder to network (optional)
5.
Turn on power switch and allow recorder to boot up.
1
Advertisement
Table of Contents
