Brake System Warning Light - Chevrolet Groove 2023 Owner's Manual

Table of Contents

Advertisement

Chevrolet Groove Owner Manual (GMNA-Localizing-MidEast-17286929) -
2023 - CRC - 6/28/22
indicator lamp will keep illuminated. In case
that serious misfire is detected, the
malfunction indicator lamp will flash
constantly. Serious misfire can cause
damage to the catalytic converter. In case of
this, the electronic system of the vehicle will
switch to an emergency running procedure
so that you can continue the trip. However,
we advise you to go to the nearest Dealer
for fault removal as soon as possible. If MIL
illuminates for a while and then goes out, it
is normal, not indicating any system fault.
Caution
If the Engine Malfunction Indicator Lamp
(MIL) illuminates, it indicates that a fault
exists. Continuous driving after the MIL
has illuminated can cause damage to the
emission control system, thus reducing
fuel economy and vehicle controllability.
See the nearest dealer for vehicle repair
as soon as possible.

Brake System Warning Light

The brake system warning lamp illuminates
after the ignition is turned on and it goes
out several seconds later (if the parking
brake has been released). This indicates that
the warning lamp can work normally.
The brake system/EBD warning lamp also
illuminates when the parking brake engages.
The lamp goes out after the parking brake is
released. Fully release the parking brake
before starting the vehicle.
If the brake system warning lamp
illuminates after the parking brake is fully
released, it indicates that the brake fluid
level in the fluid reservoir is too low or an
EBD system fault has occurred.
Instruments and Controls
Do the following:
1. Carefully drive the vehicle off the lane
and then stop the vehicle.
2. Check the brake fluid level.
3. Add the recommended brake fluid until
the fluid level reaches MAX (highest)
mark. Refer to Adding Brake/Clutch
Fluid .
4. For the following circumstances, drive
the vehicle at a safe speed to the
nearest dealer to inspect the brakes and
confirm that the brake system is working
normally.
5. For the following circumstances, tow the
vehicle to the nearest dealer for
inspection and repair:
You discovered brake system leakage.
The brake system warning lamp
keeps illuminated.
The brake cannot work normally.
Caution
Do not drive with the brake system
warning lamp on.
This may mean your brakes are not
working properly.
(Continued)
61

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents