Chevrolet Groove 2023 Owner's Manual page 125

Chevrolet Groove Owner Manual (GMNA-Localizing-MidEast-17286929) -
2023 - CRC - 6/28/22
Except the brake pedal is used to disable the
function, operating switches such as parking
brake switch and clutch switch can also be
used to disable the function of the cruise
control system.
The system can be used with speed ranges
from 40 120 km/h.
1. Setting Cruise Control
Press the button, and the cruise
indicator on the instrument cluster starts
to flash, indicating that cruise control is
active. Then pull the middle button
toward SET direction, the cruise will
start, and the corresponding logo will be
displayed in the dashboard information
window. (For example, when the driver
intends to stabilize the speed at
100 km/h, the driver must firstly speed
up to 100 km/h. When the speed reaches
100 km/h, he/she shall press the
toggle button and then pull the toggle
button towards the SET direction. At
this time, release the accelerator pedal,
and the vehicle will continuously run at
the speed of 100 km/h). After setting the
cruising speed, you can also use the
accelerator pedal to accelerate in the
normal method; after the accelerator
pedal is released, the system will recover
the speed to the original cruising speed.
After enabling the cruise function, never
move the shift lever into neutral without
stepping on the clutch pedal. Otherwise,
the engine may over speed and be
damaged.
2. Deactivating Cruise Control
If you are to immediately decelerate in
case of any emergency in front during
cruise control, press the brake pedal or
clutch pedal, or press the cruise
deactivation button
button towards direction. The vehicle
exits the current cruise state and enters
the cruise activation state, and the cruise
indicator of flashes. If you press the
button in the cruise state, the whole
,
cruise system will be deactivated and the
instrument indicator will go out.
3. Cruise Recovery
When the vehicle exits from the cruise
state and enters the cruise activation
state, if you are to carry out the cruise
control at the previous cruising speed,
you just need pull the toggle button
once towards the RES+ direction. Then
Driving and Operating
cruise control is carried out at the
previously-saved speed recovered. For
example, the cruising speed is 60 km/h
before braking and becomes 50 km/h
after braking, and at the time the cruise
indicator of instrument flickers. Pull the
toggle button once towards the RES+
direction; the cruise indicator will be
normally on, and the vehicle will
automatically speed up to 60 km/h and
enter the cruise control state.
4. Increase Cruise Control Speed
Pull the toggle button towards the RES+
direction and the set cruising speed will
or pull the toggle
rise without the need to press the
accelerator pedal. The speed will rise by
1 km/h every time you pull up the
switch once. If the toggle button is kept
pressed, the vehicle speed will
continuously rise. Once the switch is
released, the running speed will be saved
into the memory and the vehicle will
cruise at the speed.
5. Decrease Cruise Control Speed
Pull the toggle button towards the SET
direction to reduce the cruising speed.
The speed will reduce by 1 km/h every
time you pull down the switch once.
If the toggle button is kept pressed, the
125