Brinkmann 810-6640-S Assembly And Operating Instructions Manual page 11

6 burner gas grill
Table of Contents

Advertisement

6. If burner does not ignite using the igniter, see "Match Lighting the Main Burners" section.
7. To turn off, turn each control knob clockwise until it locks in the "OFF" position. This does not turn off
the gas flow from the cylinder.
Note:
If burner does not light or flame is too low, See "Trouble Shooting" section of the owners
manual.
MATCH LIGHTING THE MAIN BURNERS:
1. Open lid before lighting.
2. Make sure all control knobs are in the "OFF" position.
3. Place a paper match in the end of the matchlighter. Strike the match and
place through lighting hole in the left hand side of the grill to approximately
1/2" (1 to 2 cm) from the burner.
4. Turn on the FAR LEFT burner control knob to the "HIGH" position. The
burner should light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait
5 minutes for gas to dissipate and repeat lighting procedure.
6. Once lit, light adjacent burners in sequence by pressing in and rotating the
control knob to the "HIGH" position.
7. If the burner does not light within the first few attempts of match lighting, there
is a problem with the gas supply. Turn off the gas at the burner and cylinder.
DO NOT attempt to operate the grill until the problem is found and corrected.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is in the "OFF" position.
3. Push and hold down side burner control knob and SLOWLY (2 to 3 seconds)
turn to "HIGH". You should hear the igniter click.
Note:
Step 3 may need to be repeated 2-3 times to light side burner.
4. If ignition does NOT occur in 5 seconds, turn control knob to "OFF", wait 5
minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, see "Match Lighting the Side Burner" section.
6. To turn off, turn control knob clockwise until it locks in "OFF" position.
Note: If burner does not light or flame is too low, See "Trouble Shooting" section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open the lid to the side burner before lighting.
2. Turn the burner control knob to "OFF".
3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the
burner.
4. Turn the side burner control knob to the "HIGH" position. The burner should
light within 5 seconds.
5. If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and
repeat lighting procedure.
6. If the burner does not light within the first few attempts of match lighting, there is a problem with the gas
supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem
is found and corrected.
Note: If burner does not light or flame is too low, See "Trouble Shooting"
section of the owners manual.
Note: Observe flame height when lit: Flame should be a Blue/Yellow color
between 1"–2" when burner is on "HIGH".
See section in manual on burner adjustment to adjust flame.
Lighting Hole
Matchlighter
10

Advertisement

Table of Contents
loading

Table of Contents