Lincoln Electric POWER FEED 25M Service Manual page 26

B-8
SMAW (Stick) Welding Display
MSP4 OPERATION
CC STICK MODES
PROCESS
Stick Soft(7018)
Stick Crisp(6010)
ARC CONTROL
ARC FORCE
(Soft)-10.0 to Arc Force adjusts the short cir-
(Crisp)+10.0 cuit current for a soft arc, or for
a forceful, driving arc. It helps
to prevent sticking and shorting
of organic coated electrodes, par-
ticularity globular transfer types
such as stainless and low
hydrogen. Arc Force is espe-
cially effective for root pass on
pipe with stainless electrode
and helps to minimize spatter
for certain electrodes and pro-
cedure as with low hydrogen,
etc.
All manuals and user guides at all-guides.com
OPERATION
FIGURE B.3
194
WFS AMPS
LESS MORE
AMPS AMPS
START TIME:
0 to 10 seconds
MODE
1
2
WAVEFORM CONTROL TECHNOLOGY
IR PORT
CC Stick Soft
WELD MODE
ARC CONTROL
DESCRIPTION
POWER FEED® 25M
0
n
VOLTS TRIM
OUTPUT
OUTPUT
ON
OFF
START OPTIONS
FUNCTION
If no remote control is installed,
this control sets the time for
the weld output to ramp up or
down from a preset Start cur-
rent to the preset Weld current.
Use the WFS/AMP knob to
adjust Start current while the
Start Options LED is displayed.
Stick
I
I
SETUP
START OPTIONS
END OPTIONS
SET
END OPTIONS
No arc ending options are active for
SMAW (Stick) welding modes.
B-8