OfficeSource PLTEAB4872BUONF Assembly Instructions

Table of Contents

Download this manual

ASSEMBLY INSTRUCTIONS

MODEL: PLTEAB4872BUDECONF

ASSEMBLY INSTRUCTIONS

Before assembly, please remove all parts from the carton, verifying that you have the correct quantities, and read all the instructions.

ATTENTION

Ensure all bolts and screws are tightened, check bolts and screws every 6 months.

If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts.

Failure to follow these warnings may result in injury.

Last Updated: 02/2021

Last Updated: 03/2023

ASSEMBLY INSTRUCTIONS

MODEL NO. PLTEAB4872BUDECONF

1 of 4

OFFICESOURCE.COM

Table of Contents

Need help?

Do you have a question about the PLTEAB4872BUONF and is the answer not in the manual?

Page 1 Ensure all bolts and screws are tightened, check bolts and screws every 6 months. If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts. Failure to follow these warnings may result in injury. Last Updated: 02/2021 OFFICESOURCE.COM Last Updated: 03/2023...
Page 2 Place the Table Leg Frame on the Drawing Name bottom side of the table top Center Trunk Column Side Support Screw M6x10 Handset Screw 5x20 Screw 3x20 Power Cable Allen Key 5 Step. Step. 2 of 4 Last Updated: 02/2021 OFFICESOURCE.COM Last Updated: 03/2023...
Page 3 MODEL NO. PLTEAB4872BUDECONF ASSEMBLY INSTRUCTIONS ® MODEL: PLTEAB4872BUDECONF Detail B Detail A Tighten up the screws Step. Step. Put Handset's connecting line through the hole below the Left Trunk Step. 3 of 4 Last Updated: 02/2021 OFFICESOURCE.COM Last Updated: 03/2023...
Page 4 3 seconds 2. Continue pressing both buttons until both columns are in the lowest position 3. The table will rebound 2-5mm 4. Release the buttons, now the table is operational Step. 4 of 4 Last Updated: 02/2021 OFFICESOURCE.COM Last Updated: 03/2023...