OfficeSource PLTECAB6078ECOWF Assembly Instructions

ASSEMBLY INSTRUCTIONS

MODEL NO. PLTECAB6078ECOWF

ASSEMBLY INSTRUCTIONS

MODEL: PLTECAB6078ECOWF

Before assembly, please remove all parts from the carton, verifying that you have the correct quantities, and read all the instructions.

1 of 5

ATTENTION

Ensure all bolts and screws are tightened, check bolts and screws every 6 months.

If any parts are missing, broken, damaged or worn, stop use of product until repairs have been made using factory authorized parts.

Failure to follow these warnings may result in injury.

Last Updated: 02/2021

OFFICESOURCE.COM

Last Updated: 03/2023

Table of Contents

Need help?

Do you have a question about the PLTECAB6078ECOWF and is the answer not in the manual?

Page 1 ASSEMBLY INSTRUCTIONS MODEL NO. PLTECAB6078ECOWF ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS ® MODEL: PLTECAB6078ECOWF Before assembly, please remove all parts from the carton, verifying that you have the correct quantities, and read all the instructions. 1 of 5 ATTENTION Ensure all bolts and screws are tightened, check bolts and screws every 6 months.
Page 2 ASSEMBLY INSTRUCTIONS MODEL NO. PLTECAB6078ECOWF ASSEMBLY INSTRUCTIONS ® MODEL: PLTECAB6078ECOWF Parts List Place the Table Leg Frame on the Drawing Name bottom side of the table top. Column Right Trunk Left Trunk Inner Trunk Side Support Feet Center Post Bracket (Right)
Page 3 ASSEMBLY INSTRUCTIONS MODEL NO. PLTECAB6078ECOWF ASSEMBLY INSTRUCTIONS ® MODEL: PLTECAB6078ECOWF Put Handset's connecting line through the hole below the Left Trunk. Detail B 90° 120° Customized Option : Use Allen Key 4 to Rotate Center Post Bracket at the angle you want.
Page 4 ASSEMBLY INSTRUCTIONS MODEL NO. PLTECAB6078ECOWF ASSEMBLY INSTRUCTIONS ® MODEL: PLTECAB6078ECOWF Detail C Tighten up the screws. Step. Step. 4 of 5 Last Updated: 02/2021 OFFICESOURCE.COM Last Updated: 03/2023...
Page 5 ASSEMBLY INSTRUCTIONS MODEL NO. PLTECAB6078ECOWF ASSEMBLY INSTRUCTIONS ® MODEL: PLTECAB6078ECOWF ※ Important ※ Reset the table before use : 1. Press and hold & for more than 3 seconds. ∧ ∨ 2. Continue pressing both buttons until both columns are in the lowest position.