Maintenance - Husqvarna 2-20DT Global Operator's Manual

Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 8 .
WARNING:
maintenance, stop the motors and
disconnect the power plug from the power
source. Make sure that all drives stop.
General product maintenance
Make sure that nuts and screws
are tight.
Make sure that the power plug
and extension cable are in
good condition and not dam-
aged.
Do a check of the electrical
components, the cables and
the connections for wear and
damages.
Do a check of the RCD.
Examine the electric motor for
dirt and damage.
Make sure that the dust extrac-
tor hose is not damaged and
that there is no blockage.
Empty the dust extractor.
Do a check of the of the abra-
sive separator, the separator
tray and the feedspout.
Clean the product.
Do a check of all safety devi-
ces.
Do a check of the brush seal
and magnetic seal for wear.
22

Maintenance

Before you do
Use personal protective
Personal protective
Before you do the
Each 3 h
*
X
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
12 h after
Daily
service
* *
*
*
*
*
*
X
X
X
Each 3
Yearly
months
2037 - 001 - 07.02.2023